Clik here to view.
Flexible hose for Reuse in multiple different assemblies - solution for...
If you look how to create simple flex hose so that it could be reused in multiple assemblies of different geometry – this is for you. Please note, that proposed technique will fit only for cases when...
View ArticleRemove location not working
Hello, I am trying to remove a location in cabling but the following message appears on the bottom: "Splice location can not be removed". Is there some way to force to remove it? Thanks!
View ArticleClik here to view.
Harness table not updating
I have a harness and added a pin parameter SEAL. I first edited the parameter directly and placed a value. In the drawing, there is a table with &asm.mbr.connprm.pin.SEAL. It showed the added...
View ArticleClik here to view.
Change routing of wire that is using Network
I am very new to creating harnesses and am trying to figure out how to change the routing of a wire that is not routing along the network how I would like it. In the picture the wire in question is in...
View ArticleDeleting or nulling parameters via term table
Is there a way to delete, null or clear a parameter field via the term table? I want to clear the field if there is something there already. Doing a "Delete Parameter" from the parameter editor seems...
View ArticleLimit on the number of common Entry Ports/Pins shown in Parameter editor
Is there a way to get all of the common Entry Ports/Pins to show in the Parameter Editor? When I open it, not all of the common Entry Ports/Pins are shown, only about 10 total. It would be nice to be...
View ArticleClik here to view.
Branching in Creo Schematic
If you use branching in Creo Schematic, how does Pro Cabling handle it to do the routing to the components?
View ArticleAdding datatable after creating fiber artifacts and shapes
Dear Mr. Jim, 1. The Creo Schematics version I'm working in is 3.0 with datecode M020.2. I've created block, fiber and port artifacts and shapes through catalog explorer in a design by manually adding...
View ArticleClik here to view.
Getting Harness (Wire or Cable) in Shrink Wrap
While creating shrink wrap for large assemblies, particularly harness geometry is missing in the Shrink wrap. Only the connectors and terminals are there, harness routing is not there.Is there any way...
View ArticleClik here to view.
Exporting schematics from other systems into Creo/Solidworks (using Visio, etc)
Hi folks, I'm just sending this out here to see response. We partner with external tool design resources who create designs and full documentation to us. Often times the tool design includes...
View Article