Hello all,
So we've recently switched to modeling piping using the Pro Piping module and it hasn't exactly been smooth sailing. I'm currently trying to figure out how to create weldment drawings for a couple runs of pipe, two lengths and an elbow for example. After looking through PTC University's 'Piping Using Creo Parametric 2.0' guide, it seems like the 'extract model' command would help me do that. I could just pick whatever lengths and fittings needed to be in the weldment, combine them into one part, and then make a drawing of that part.
Unfortunately whenever I try to use this command I get the error 'Member creation failed. Solid Construction aborted'. I'm following the tutorial exactly so I'm not exactly sure what the problem is.
Anyone have any experience using this command or have any other solutions to creating weldment drawings with Pro Piping? Worst case scenario I could just create multiple assemblies and create a separate pipeline in each but that seems like a waste of Pro Piping.
