In the past we used Pro/DIAGRAM to do electrical and we were able to use an OVERLAY to add the Wiring Diagram to the 3D harness drawing. We liked this process since it only required us to manage one "Drawing" in the system. Essentially, the drawing was a BOM with the harness in 3D on it and flattened, then the last sheet was an overlay with the wiring Diagram on it.
I'm not a Cabling/Schematic expert; however, I'm being told that in Creo Schematics they took away the overlay process. Any truth to that? Do I now need to create a separate drawing for all the Wiring Diagrams?
Thanks.