Hello all. I recently started performing Creo Cabling in my office.
So, I have created a cabling assembly with two connectors and a cable attached between. I have another assembly where in there are two terminals (connector mates to these terminals). Now, is it possible to import the connector assembly and mate the two connectors to the two terminals, while the cable extends on its own. Right now, once i mate one connector, i cannot mate the other end to the other terminal as the cable is short.
I could change the cable length, but i need a solution wherein I can import to any assembly and the cable automatically adapts.
I hope i have been able to convey my problem.