Hi all,
I have a question concerning the parameter end_type at a branch. port0 and port1 have the same end_type, port2 (the port at the branch outlet) has a different one. Into the column of the “nend_type” in the ptd-file I wrote the end_type of port2 and in the column “end_type” the end_type of the other two ports. If I insert this fitting into an assembly and place another fitting on port2 there appears an error at the end compatibility of the design rule check that the end_type of port2 is the same than the others. What could be the reason for this error?
Regards, Klara